Wheat packaging machine maintenance and fault detection

The wheat packaging machine is a mechanical device. If we can better maintain the packaging machine, it will greatly increase the service life of the machine. It takes time to produce faults for a long time. It is unavoidable to find out the cause and solve the problem in time when the equipment is faulty. We should do the following. Here are some common wheat packaging machine maintenance and fault detection methods (only for your reference, if not Where you understand, please contact our after-sales department.

A wheat packing machine maintenance instructions

1 , regular inspection of wheat packaging machine parts, once a month, check the worm gear, worm, the lubrication block on the bolts, bearings and other moving parts are flexible and wear conditions, found that defects should be repaired in time, not reluctant to use.

2, the packaging machine should be placed on wheat dried clean room use, it shall not contain acids and other corrosive gas flows place on the body in the atmosphere used.

3 , after the use of wheat packaging machine or stop, you should remove the rotating drum to clean and brush the remaining powder inside the bucket, and then install, ready for the next use

5 , if the decommissioning time is longer, the whole body of the wheat packaging machine must be wiped clean, the smooth surface of the machine is coated with anti-rust oil, covered with a cloth

Second, wheat packaging machine fault detection

Question 1: The wheat packing machine is not moving (that is to say, stepping motor is blocked) or the measurement is good or bad.

Fault detection method:

( 1 ) There is debris in the material caused by excessive resistance or the cup eccentricity, in this case please shut down, remove the cup, clear debris or adjust the position of the material cup.

( 2 ) The operator will abut the bottom of the container at the outlet of the cup and change the method of operation.

Question 2: Measurement is not allowed after changing the wheat packing machine specifications or materials.

Fault detection method :

( 1 ) The position of the agitator divider is not suitable. It needs to be adjusted so that the lower end of the divider is about 10-15mm from the screw .

( 2 ) After the filling is completed, there is a phenomenon of leakage of the material, and the leakage prevention net is added.

Question 3: The wheat packaging machine does not operate with a stirring motor.

Fault detection method :

( 1 ) Due to thermal overload relay tripping. At this time, open the electric control cabinet to see the thermal overload relay trip indicator (green) eject. The cause of the malfunction is a shock caused by the load of the stirring motor being too large or being stopped.

( 2 ) The power supply is missing phase.