Miniature submersible pump compact and lightweight, in rural areas play an important role in production and living, should pay attention to the following points in use.
A purchase submersible pump should pay attention to its model, flow and lift. If the specifications used inappropriately, will not be able to get enough water, can not play unit efficiency. In addition, we should also clarify the direction of rotation of the motor, some types of submersible pumps forward and reverse can be water, but the reversal of the small amount of water, the current is large, the reverse will damage the motor windings. To prevent submersible pump leakage in the water when working under the accident caused by electric shock, leakage protection switch should be installed.
Two. When installing a small submersible pump, the cable should be overhead, the power cord should not be too long. Do not force the cable when the unit is launching, which may cause the power cord to break. Submersible pumps do not sink into the mud, otherwise it will lead to bad heat and burn the motor windings.
Third, try to avoid starting at low pressure. When the voltage is too low, the motor speed will drop. If it is less than 70% of the rated speed, the centrifugal switch will be closed and the starting winding will be closed Power for a long time to heat or even burn the windings and capacitors. Do not switch the motor on and off frequently. This is because the pump will run back when it stops. If it is turned on immediately, the motor will start to load, causing the starting current to be too large to burn the winding.
Four. Do not allow the pump long-term overload operation, do not pumping large amounts of water, dehydration pump operation time should not be too long, so as not to overheat the motor and burned. During the operation of the unit, the operator must keep an eye on whether the working voltage and current are within the values ​​specified on the nameplate. If not, the motor should be stopped to find out the cause and solve the problem.
V. usually more than check the motor, found under the crack, rubber seal ring damage or failure, etc., should be promptly replaced or repaired to prevent water penetration into the machine.
Zinc or Nickel Plating Production Line
Metal electroplating line is widely used in aircraft and auto parts, machinery parts, metal, hardware processing industries, including cooper plating, silver plating, zinc plating, nickel plating, gold plating, chrom plating, anodizing, electrophoresis production line,etc.
Zinc-nickel alloy is an anti-corrosion coating with excellent corrosion resistance. At the same time, it has good mechanical properties and does not change the mechanical properties of the steel after plating. It has excellent brazing properties and is easy to weld under various conditions. The internal stress of the coating is small, which is comparable to that of the cadmium coating in the torsion-tension test. The plating solution has good dispersing ability and covering ability, high current efficiency, bright and smooth coating.
The zinc-nickel alloy plating bath has weak acid chloride type, sulfate type and alkaline zinc acid type.
The surface condition and processing requirements during electroplating, select the appropriate steps, and perform the necessary finishing processing on the surface of the part, so that the part has a smooth and clean surface, which is an important link in obtaining a high-quality coating.
Zinc Or Nickel Plating Production Line,Zinc Plating Line,Zinc Plating Production Line,Nickel Treatment Production Line
Wuxi Xingyi Intelligent Environment Protection Equipment Co.,Ltd. , https://www.wxxingyi.com